The Getaway Mountain Mod Installation Instructions

 

1. Remove lock bar, and playfield glass (the mod can be installed without lifting the playfield provided you can reach the back of the supercharger).

2. Remove nut that holds the supercharger to the center of the playfield.

 

3. Remove the 3 screws that hold down the top right playfield plastic. It's not required, but recommend to remove the clear piece of plastic at the corner of the supercharger. Remove both pieces, the lower playfield plastic will not be used.

 

4. Remove one of the GI lights and replace it with the one provided with the pigtail connector.

 

5. Connect the mountain’s LED light strip connector to the new lamp’s connector.

 

6. Pull up on the front supercharger leg tab and lift over the screw.

 

7. Place the mountain into the loop of the supercharger as shown.

 

8. While pulling up on the supercharger loop, rotate the mountain so that the front bump goes under the loop. Line up the two mounting holes with the front and rear screw points.

 

9. Reinstall the nuts on the two mountain attachment points, place the supercharger front tab back over the screw point and reinstall its nut. You can also now replace the plastic above the mountain if desired. You have completed installation of the Mountain Mod!